BSI - Colla epoxi 20 minuti (128 g) FINISH-CURE Made in USA

23,00 €
Tasse incluse
bSi
6592
Quantità
Non disponibile

BSI - Colla epoxi 20 minuti (128 g) FINISH-CURE Made in USA
100% secure payments

Questo prodotto può essere acquistato con COD

 

 

FINISH-CURE 20 MIN. FINISHING EPOXY (113.6g) Made in USA

FINISH-CURE™ 20 min. epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint. FINISH-CURE™ can be sanded the easiest of all our epoxies and is excellent for the sheeting of foam core wings. Allow 8 hours for full curing. For best results, FINISH-CURE™ should be heated to a temperature above 85 degrees F or applying light weight fiberglass, lay cloth on balsa first, then brush on FINISH-CURE™. When fully saturated, go over the surface with a heat gun, and then squeegee off excess epoxy with a playing card from an old deck. Heat and remove excess several times for a light weight finish. If room temperature is below 70 degrees F use a heat gun on the surface several times for the next 2 hours. When dry, lightly sand, then fill surface with a low weight spakeling compound, scrapping off excess with a playing card. Sand to a smooth finish ready for primer. For heavy weight fiberglass, apply the epoxy before and after laying down the cloth. FINISH-CURE™ is best mixed in a disposable cup.

Works Best On:

Fiberglass

White Foam

Laminating

Water-Resistant

Works Good On:

Balsa Wood

Hard Wood

 

bSi
6592
  • TRASPORTO € 9,90
  • PAGAMENTO SICURO